Sfoglia per Relatore
Analisi di caratteristiche fluidodinamiche di flussi bifase e trifase
2016/2017 DI PLACIDO, MASSIMILIANA
Analisi sperimentale delle caratteristiche di flussi multifase olio viscoso-acqua-aria in condotti orizzontali con variazione di sezione
2014/2015 GARAVAGLIA, CHRISTIAN
Analisi sperimentale delle caratteristiche fluidodinamiche di flussi bi e trifase in condotti a sezione variabile
2014/2015 BARKI, SIMONE
Analisi strutturale e termica di un utensile per foratura
2013/2014 BERGNA, PAOLO
Analisi termica di dissipatori alettati per lampade a LED
2012/2013 PANZERI, ELENA
Analisi termica di uno scambiatore di calore a tubi elicoidali per impianti alimentati a biomassa
2013/2014 VILLA, PAOLO
Analysis and simulation of the thermal behavior of a liquefied natural gas tank exposed to fire
2017/2018 TAMPONI, LUCA
Analysis of an off-shore pipeline : fluid properties and flow modelling
2016/2017 MOLARO, ANDREA
Analysis of electrical heating technologies from a flow assurance point of view
2016/2017 ZAMBETTI, GIOVAN BATTISTA
Analysis of heat and moisture transfer in building components by conjugate modeling
2012/2013 NESPOLI, LORENZO
Analysis of the simultaneous re-injection of water and natural gas to reduce gas flaring in oil and gas fields
2014/2015 VARANO, MASSIMO
BOS measurements of the temperature field for free convection of air past a heated surface at low Rayleigh numbers
2012/2013 SENYUZ, YIGIT
Caratterizzazione sperimentale di flussi acqua olio in condotti circolari orizzontali attraverso brusche contrazioni di sezione
2012/2013 BRIGIDO, GENNARO
Case Study of A Monitoring and Prediction System in EQUA Srl in line with Booster Optimisation Level to Enhance Efficiency of Energy Usage in Winter Condition
2022/2023 Avyattana
Characterization of three-phase air-water-oil in a downward inclined pipe : pressure gradient and interfacial wave parameters.
2021/2022 Campagna, Alessandro
Convective and radiative heat transfer in a battery pack: modelling, simulation and experimental validation
2012/2013 SACCOCCIO, MATTIA
Design and validation of a heat sink for consumer electronics using topology optimization
2016/2017 DAMONTE, ALBERTO
Design of a liquid hydrogen tank for a liquid hydrogen airplane
2012/2013 OPPICI, FRANCESCO
Development of an advanced numerical model for a concrete-based thermal storage system using steam as heat transfer fluid
2020/2021 Bordigoni, Alessandro
Effect of the down-slope on the structure and the pressure losses of an oil-water stream
2020/2021 Franchi, Riccardo Attilio
Legenda icone accesso al fulltext
- File accessibili da tutti
- File accessibili dagli utenti autorizzati
- File accessibili da tutti o solo dagli utenti autorizzati, a partire dalla la data indicata nella scheda
- File non accessibili